Last updated on November 16th, 2022 at 03:40 pm
what are Most Common 2015 & 2013 Chevy Impala Starting Problems?
If you are reading this post, it simply means you want to learn about the most common 2015 / 2013 Chevy lmpala starting problems.
For over 60 years, Chevrolet has struggled with several issues with their vehicle models. In as much as the Chevy Impala is one of the most America’s favorite cars, Impala is still known for its fair share of problems.
These issues range from gas cap problems, faulty instrument panel gauges, jolting, shifter malfunction, inadequate transmission pressure control solenoid, electrical issues, and to mention a few.
Notwithstanding, the owners of the 2013 and 2015 models of Chevy Impala have reported over 69 issues related to the starter- (under the electrical system) and the slow response and delayed acceleration due to electronic throttle problems. Perchance, this starter issue has been a persistent worry to drivers and owners of Chevy vehicles, especially the Impala models of 2013 and 2015.
Since the implementation of the electronically controlled throttle known as a drive-by-drive system, these models have had issues as you step on the gas.
Essentially, it takes more than a second before your vehicle begins moving. These seconds though, may feel like an eternity when you are driving. Possibly, at best, it’s an annoying experience, and at worst, it could be downright perilous, like when you are trying to cross the traffic.
Nevertheless, this article will examine and explore the following contents; what are common 2015 Chevy impala starting problems, common 2013 Chevy impala starting problems, where are the 2015 & 2013 Chevy impala starter locations, why does my Chevy impala keep shutting off, and more.
Without much ado, let’s get started!
What Are Common 2015 Chevy Impala Starting Problems?
The 2015 Chevy Impala is an excellent vehicle to buy when it is new. Although, it won the Best Large Vehicle for Families and Best Large Vehicle for the Money awards in 2015. Notwithstanding the above records, it still has some common issues relating to starting. Thus, these starting issues emanate from a lousy starter solenoid or motor experiencing electrical problems, dirt in the starter wiring, and damage to electrical components.
However, starting problems only happen sometimes, so you get your starter and its parts inspected to avoid being unable to get out of an unfamiliar place.
Common 2013 Chevy Impala Starting Problems.
The most common reasons a 2013 Chevy Impala would have a starting problem are a failed starter, dead battery, and faulty alternator. These would make your vehicle have a starting problem, so consult your mechanic immediately if you notice or observe that your car is refusing to start.
Where Are The 2015 & 2013 Chevy Impala Starter Locations?
The 2015 Chevy Impala starter location is on top of the engine, near the transmission side of your vehicle. At the same time, the 2013 Chevy Impala starter is situated in the engine’s base, close to where the transmission meets the engine.
Why Is My 2013 Impala Not Starting?
If your 2013 Impala is not starting, then the starter, battery, or alternator would have caused it not to start. Although, I will explore this without much ado!
If you place your ignition in the start position, a discrete signal will be sent to the Body Control Module (BCM), notifying it that the ignition is in the start position. Within a few seconds, the BCM sends serial data information to your vehicle’s Engine Control Module (ECM) that, enables cranking to take place.
In as much as the ECM would monitor the positions of the park/neutral switch and the clutch pedal sensor. Perchance the transmission is the park or neutral, or if you press the clutch pedal, there will be no DTCs that inhibit the engine from starting, but if there are Diagnostic Trouble Codes (DTCs);
Perchance the engine of your 2013 Impala won’t start because there is no voltage supply from the ECM through the STRTR relay to the X2-S terminal of the starter solenoid, which will energize to supply the starter from the B terminal the required battery voltage to enhance the cranking of the engine.
Regularly seek a professional’s help if your vehicle won’t start.
What Are Common Problems With Chevy Impalas?
Chevy Impala vehicles have struggled over the years with a series of issues. The starting issues are prone to mostly all the models of the Chevrolet. But that doesn’t make Chevy vehicles terrible vehicles indeed. Hence, the common problems with the Chevy Impalas are listed below.
Here you have them!
- Shifter malfunction.
- Gas cap problems
- Lousy instrument panel gauges.
- Jolting or jerking when accelerating.
- Transmission problems
- A high-pressure power steering hose can leak fluid. The ignition key is stuck due to failed starter motor.
- Intake manifold gasket failure.
- Pass-lock issues.
- Excessive oil consumption.
These and many more are common problems with Chevy Impalas. Notwithstanding, most models of Chevy impalas are reliable as they score 4.0 out of 5.0 in reliability ranking, 5th out of 12 vehicles in its segment. In essence, the 2020 model gave 3.5 out of 5.0 according to J.D Power and a 4.4 rating for the older model of 2005 by Kelley Blue Book as regards consumer reviews.
Why Is My Impala Making A Clicking Noise?
If your Chevy Impala makes a clicking noise, it could be from the wheels, which can be disconcerting. Although the steering system of your vehicle is a complex system with many moving parts, many of these components could cause a strange noise, such as a clicking or popping noise. So, this uncommon noise from the wheels may be nerve-wracking. Thus, it would help if you inspected the clicking noise from the wheels or other areas.
Hence, the root of this annoying problem is likely a faulty CV joint, lousy struts, loose hubcaps, and a loose drive belt or drive belt tensioner.
Why Does My Chevy Impala Keep Shutting Off?
Your Impala is to function like a well-oiled machine, but sometimes it struggles in unexpected places.
In essence, if there is no indication of the check engine light as your vehicle keeps shutting off at low or high speed. Then the following include malfunctioning transmission, low fuel pressure, broken fuel pump, dirty or defective fuel injectors, lousy oxygen sensor, loose or corroded wires in the wiring harness, restricted or clogged EGR valve, and bad idle air control actuator are potentially the causes.
How Much Does A Starter Cost For A 2012 Chevy Impala?
The cost of replacing a 3.6L V6, 98,000 miles 2012 Chevy Impala is typically between $414 to $506, including labor costs of $112 to $141 and parts costs of $307 to $410.
Remember, the range may vary depending on your location.
How Do You Change The Alternator On A 2009 Chevy Impala?
Having known the symptoms of a bad alternator in this post, replacement of the alternator when it is faulty wouldn’t be a problem, in any case. Below are the procedures to replace or change a lousy alternator on your 2009 Chevy Impala.
- Detach the negative battery wire.
- Disconnect the wire connections from the alternator’s back.
- Lose the belt tensioner by removing the drive belt from the pulley.
- As the belt is off, disengage the mounting bolts that connect the alternator to its bracket.
- Take away the alternator from the bracket.
- Compare the alternators for the mounting holes and check for matches.
- Use a ratchet to tighten the mounting bolts as you install the new alternator.
- Use the tensioner arm to slip the drive back to position as you reinstall all cable/wire connections.
- Review the installation process and use the micrometer to test the alternator’s output.
Note: Endeavor that the battery is charged fully before installation because using a new alternator to charge a low-voltage battery could damage the alternator.
How Do You Know If You Have A Bad Alternator?
The alternator, being a vital part of all electrical components of your vehicle, may fail just like any other part.
If it becomes imperfect or faulty, the battery is not charging, and the car will not start; perchance, problems like stalling and starting might leave you running late on an important business trip. Similarly, some safety components, such as the headlights, would not work either.
Hence, below are other common symptoms of a failed alternator.
- Electrical accessories such as; radio, power windows, and the air-conditioning system could falter with a lousy alternator.
- A burning smell could indicate an alternator pulley or drive belt issue.
- Lit dashboard warning lights like battery lights, charging system lights, or even check engine lights would all entail faulty alternators.
- Misalignment of an alternator or worn-out pulley bearings could cause whining or squealing noise.
Now you know! Quality electrical systems inspections from your certified mechanic are necessary if you notice any of the above-listed signs.
How Much Does An Alternator Cost For A 2013 Chevy Impala?
If your alternator is terrible and you intend to replace it in your 2013 Chevy Impala. Then, the average cost is $270 to $800, including the price of parts and labor. Perchance, this cost price may vary as regards your location as it excludes tax and other fees.
Why Does My Chevy Impala Jerk When I Accelerate?
Your Impala’s engine is a pump that mixes air, fuel, and a solid ignition to run correctly. So, if any of these three variables malfunctions, you will not have optimal combustion. Although, jerking when accelerating is a prevalent issue for Chevy Impala.
However, if you experience such in your vehicle, you have problems with your fuel delivery system, exhaust system, motor mount, the engine is misfiring, and more.
Let’s explore these issues causing your Impala to jerk when you accelerate!
Faulty Motor Mount Or Transmission Mount
Since the motor and transmission mounts are responsible for connecting your vehicle’s engine and transmission to the chassis, if any of them should break, your car would jerk when braking, accelerating, or even putting in the gear.
Fuel is the integral blood of any vehicle to run effectively. If your fuel injector is clogged or malfunctioning, your Impala will likely have a jerking sensation. On the other hand, a faulty fuel pump or fuel filter can also cause the jerking of your vehicle when you accelerate.
Remember that exhaust air has to pass through the catalytic converter before the tailpipe. If the catalytic converter is clogged, your Impala will struggle and jerk when accelerating. In essence, the clogging of the catalytic converter will cause your vehicle to have a reduced speed, unlike what you intend to drive, and you will also feel choking sensations from the engine’s exhaust system.
A misfiring engine emanates from a few things, such as; lousy spark plugs, faulty coil packs, or even bad plug wires. So, a misfire is a common reason your Impala vehicle jerks when accelerating.
Notwithstanding, those factors mentioned earlier, except lousy motor or transmission mount, should trigger the check engine light to come on. So, ensure you get the proper trouble code from the Scan Tool to solve the issues promptly.
To summarize this guide, the 2015 & 2013 Chevy impala have starting problems associated with a faulty alternator, a bad battery, and a defective starter. The starter on today’s modern vehicles (Chevy Impalas) is attached to the rear of the motor, where the gear aligns with your vehicle’s flywheel to begin the ignition process.
Peradventure, if the starter fails, your vehicle won’t start. On the other hand, a dead battery and a faulty alternator may also be responsible for your car not starting at the required time.
Notwithstanding, every memorable drive you would have or have experienced begins with your vehicle’s starter’s successful and efficient operation.
Get a professional mechanic to help you diagnose, proffer solutions, and estimate the cost of replacing any faulty vehicle components. Do like and share this guide with others!